Electrical Shock Hazard - Sharp SDW6506JS Installation Manual

Hide thumbs Also See for SDW6506JS:
Table of Contents

Advertisement

INSTALLATION INSTRUCTIONS
Route the cable from the power supply through the hole (cable
3
must extend to the front-right-side of the opening). Extend cable
to 6" (15.2 cm) in front of unit and tape the cable to the floor
to keep it from moving while the dishwasher is moved into the
cabinet opening.
6" (15.2 cm)
FIGURE F
METHOD 2 - POWER SUPPLY CORD
The power cord and connections must comply with the National
Electrical Code, Section 422 and/or local codes and ordinances.
Recommended cord length is 54" to 64".
• A mating 3 prong, ground-type wall receptacle is required in a
cabinet next to the dishwasher opening.
• A power cord kit part #BK500 is available for purchase from an
authorized parts dealer.
Drill a 1
1
/
" (3.8 cm) hole in the cabinet rear or side. See Figure
2
1
H for preferred and optional locations.
Smooth edges of hole for power cord.
2
Attach power cord to dishwasher before moving it into the
3
opening. See Step 7 on page 11 for instructions.

ELECTRICAL SHOCK HAZARD

• Plug into a grounded 3 prong outlet.
• Do not remove the ground prong from the power
cord plug.
• Do not use an adapter.
• Do not use an extension cord.
• Failure to follow these warnings can result in death,
fire or electrical shock.
Direct
wire
Tape
1
3"-4
/
4
(7.6 cm-10.8 cm)
WARNING
PREPARE TO CONNECT WATER LINE
Drill a
1
Figure G for preferred and optional locations.
Attach copper tubing to the manual shutoff valve.
2
"
Slowly feed the copper tubing through the hole into the opening.
3
Continue feeding the tubing until there is enough length to
connect to the inlet (front-left side of the dishwasher) yet remain
within the required boundary.
Slowly turn water shutoff valve to ON position. Flush water into
4
a shallow pan to get rid of particles that may clog the inlet valve.
Turn shutoff valve to OFF position.
5
NOTE: The hose can be taped to the floor to secure while dishwasher
is moved into place.
9
A
B
A. Preferred locations
B. Optional locations
FIGURE G
1
/
" (1.3 cm) hole in the cabinet side, rear or floor. See
2
Copper t ubing
3"-4
3
/
" (7.6 cm-12.1 cm)
4

Advertisement

Table of Contents
loading

Table of Contents