Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
STEP 1: UNPACK DISHWASHER
IMPORTANT: If you received a damaged dishwasher, immediately
contact Sharp Customer Service.
•
SUFFOCATION HAZARD
• To avoid danger of suffocation, keep plastic bag and other
packing material away from babies and children. Do not use this
bag in cribs, carriages and playpens. The plastic bag could block
nose and mouth and prevent breathing. This bag is not a toy.
• Before you throw away your old appliance, remove the door
or lid so that children cannot hide or get trapped inside your
old appliance.
• Failure to follow these instructions can result in death or brain
damage.
With the help of two or more people, open the dishwasher
1
door slowly while one person presses down on the top of the
dishwasher. Remove the lower dish rack and all packing material.
Locate the literature package and read the User Manual for
2
operating instructions.
Close the dishwasher door until latched and stand the dishwasher
3
upright.
Properly dispose of/recycle all packing material.
4
STEP 2: REMOVE KICK PLATE(S)
Using a screwdriver, remove the two screws attaching the kick
1
plate(s) to the cabinet.
Lift off the kick plate.
2
Kick Plate
Screws (2)
WARNING
STEP 3: CHECK DOOR BALANCE
With another person holding the dishwasher to prevent it from tip-
ping, open the door slowly.
• If the door drops too freely, increase the spring tension.
• If the door closes, decrease the spring tension.
TO ADJUST THE SPRING TENSION
Grasping the spring firmly, raise or lower the hook end to the next
1
higher or lower slot and insert the hook into the slot.
NOTE: Adjust both springs (left side and right side) to the same
tension.
Retest the door. Continue moving the spring hooks higher or
2
lower until the door is balanced.
7
Advertisement
Table of Contents
