Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
STEP 6: CONNECT DRAIN HOSE
CONNECT DRAIN HOSE TO HOME PLUMBING
The drain hose will be connected to the house drain system after
the dishwasher is installed in the opening.
Drill a 1
1
/
" (3.8 cm) hole in cabinet wall or floor on the side of
2
1
the opening closest to the sink.
Grasp the sides of the dishwasher at the edges of the door panel,
2
and place the dishwasher in front of the opening.
Insert the drain hose into the hole in the cabinet wall.
3
Attach drain hose to the back of the dishwasher and secure with
4
a hose clamp.
A
B
E
CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit
connections on the air gap, waste tee or disposer. Cut on the marked
line as required for your installation.
Cutting lines
1"
3/4"
IMPORTANT: Do not cut corrugated portion of hose
• If a longer drain hose is required, add up to 42" of length for a
total of 10 feet to the factory installed hose. Use
diameter hose and a coupler to connect the two hose ends. Secure
the connection with hose clamps.
Hose Clamp
• Secure the drain hose to the air gap, waste tee or disposer with
clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
A Insulation blanket
B Water line
C Drain hose - maximum
C
lengh 10 ft (3.0 m)
D House wiring
D
E Power cord (if needed)
5
/
",
3
/
" or 1" diameter
8
4
5/8"
5
/
" or
7
/
8
8
Hose Clamp
Coupler
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using either
previously determined method.
METHOD 1 – AIR GAP WITH WASTE TEE OR
DISPOSER
Waste Tee Installation
METHOD 2 – HIGH DRAIN LOOP WITH WASTE TEE OR
DISPOSER
Fasten to underside
of countertop
Waste tee installation
IMPORTANT: When connecting drain line to disposer, make sure
that the drain plug has been removed. DISHWASHER WILL NOT
DRAIN IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching dishwasher
drain hose to the disposer.
" inside
Do not connect the drain hose to the sink drain waste tee or
garbage disposal without looping the drain hose underneath the
sink with a high drain loop. Doing so will cause the dishwasher
to not drain properly, which may allow drain water to back up in
the dishwasher tub or result in an E1 error code.
10
Disposer Installation
Fasten to underside
of countertop
32"
Min.
18"
Min.
Disposer installation
WARNING
32"
Min.
18"
Min.
Advertisement
Table of Contents
