Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
STEP 4: ADJUST LEVELING LEGS
Move the dishwasher close to the installation location and lay
1
it on its back.
Measure the height of the opening from the underside of
2
countertop to floor (lowest point).
Extend the leveling legs from the base of the dishwasher by the
3
length indicated in the following chart. Take into account any
built-up flooring which may need to be added to the rear foot
adjustment.
NOTES:
• If the floor was raised in for the front of the dishwasher, account
for this difference when adjusting the rear leveling legs.
• Final leveling leg adjustments will be made following installation
into the opening.
Adjust Leveling Legs
to Installation Height
LEVELING LEG ADJUSTMENT
Opening
Front
Height
Legs
33
3
/
"
0
4
34"
0
34
1
/
"
1
/
"
4
4
1
1
34
/
"
1
/
"
2
2
34
3
/
"
3
/
"
4
4
35"
1"
1
STEP 5A: VERIFY EXISTING UTILITY
CONNECTIONS
WATER CONNECTION
• Check that the water line reaches to the front-left side of opening
where the water connection will be made as shown in Figure G.
ELECTRICAL CONNECTION
• Check that the direct wire cable extends a minimum of 6" beyond
the front-right side of the opening, and is routed as shown in
Figure F.
STEP 5B: PREPARE UTILITY CONNECTIONS
(IF NEEDED)
PREPARE TO CONNECT POWER SUPPLY
Connect to the Power Supply using one of two Methods: Direct Wire
Cable (Method 1) or Power Cord (Method 2). Follow the instructions
specific to your installation. For both methods, a hole is drilled into
the right side of the cabinet, and the rough edges of the hole must be
smoothed or covered. For wood cabinets, sand the edge of the hole
until smooth. For metal cabinets, cover the edge of the hole with a
grommet (not provided).
Back
Legs
0
1
/
"
4
1
/
"
2
3
/
"
4
1"
1
/
"
4
METHOD 1 - DIRECT WIRE
Drill a
3
1
side of the back wall or floor of the opening. See Figure H for
preferred and optional locations.
NOTE: Wiring the dishwasher will be easier if the wire is routed
into the opening from the right side.
Smooth or cover rough edges of the hole that the wiring will
2
pass through.
8
WARNING
ELECTRICAL SHOCK HAZARD
• Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
• Failure to do so can result in death or electrical
shock.
B
A
A. Preferred locations
B. Optional locations
FIGURE E
/
" (1.9 cm) hole into the right side cabinet, or the right
4
Advertisement
Table of Contents
