Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
STEP 9: SLIDE DISHWASHER PARTIALLY
INTO CABINET
TIP OVER HAZARD
• Do not use dishwasher until completely installed.
• Do not push down on open door.
• Doing so can result in serious injury or cuts.
Position power supply.
1
• If dishwasher has a power supply cord, insert power supply
cord into the hole cut into the cabinet.
• If using a direct-wire connection, check that the wiring is on
the front-right side of opening.
Make sure the drain hose is not kinked under the dishwasher
2
and there is no interference with the water line and wiring or
any other component.
Slowly move the dishwasher into the opening a few inches at
3
a time. As you proceed, pull the drain hose, water supply hose
and cord through the opening under the sink or cabinet. Stop
pushing when the dishwasher is a few inches in front of the
adjacent cabinetry.
NOTE: Do not push against the front of the panel or on the
console, as this will cause denting.
Reposition dishwasher by
grasping both sides with
hands.
Push dishwasher completely into the opening so that the front
4
corners of the dishwasher door are flush with the cabinet doors.
NOTE: It is all right if the dishwasher fits tightly into cabinet
opening. Do not remove the insulation blanket, as it reduces the
sound level.
WARNING
Do not push against front door
panel with knee. Damage to
the door panel will occur.
STEP 10: LEVEL DISHWASHER
IMPORTANT: The dishwasher must be level for proper dish rack
operation and wash performance.
Level the dishwasher so its front panel is aligned with the adjacent
1
cabinet doors.
NOTE: With some installations, it may be easier to adjust the
front leg using a flat blade screwdriver.
• To lower - Turn the leveling leg counterclockwise.
• To raise - Turn the leveling leg clockwise.
To raise
Check that the leveling legs are firmly against the floor.
2
Close and latch the door then place level against the front panel.
3
Check that dishwasher is plumb. If needed, adjust leveling leg or
add shims until dishwasher is plumb.
NOTE: Shims must be securely attached to floor to prevent their
movement when the dishwasher is operated.
Repeat for other side of dishwasher.
4
Place level on door and rack track inside the tub as shown. Check
5
that dishwasher is level from side to side, and from back to front.
If the dishwasher is not level, adjust front legs up or down until
dishwasher is level.
Level front
to back
NOTE: Pull lower rack out about halfway. If the rack rolls forward
or back into the dishwasher, the dishwasher must be leveled again.
13
Raise one side of
the dishwasher
To lower
Level side
to side
Advertisement
Table of Contents
