Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
STEP 7: CONNECT TO POWER SUPPLY
DIRECT WIRE CABLE
ELECTRICAL SHOCK HAZARD
• Electrically ground dishwasher.
• Connect ground wire to green ground connector in
terminal box.
• Do not use an extension cord.
• Failure to follow these instructions can result in
death, fire or electrical shock.
IMPORTANT: Contact a qualified electrician. Be sure the electrical
connection and wire size are adequate and in conformance with the
National Electrical Code, ANSI/NFPA No. 70-latest edition and all
local codes and ordinances.
Confirm the power is turned off at the source.
1
Remove terminal box cover. Retain for later use.
2
Install a UL listed/CSA approved strain relief.
3
Route the direct wire cable in the channel on the right-hand side
4
of the dishwasher base. Make sure the dishwasher is not resting
on and/or pinching the wire.
Pull direct wire through strain relief in terminal box.
5
Strain relief
Connect the wires as follows using UL listed wire nuts of the
6
appropriate size to connect direct wire to 16-gauge dishwasher
wire.
POWER SUPPLY WIRE
white
black
ground wire
WARNING
TERMINAL BOX WIRE
white
black
ground connector
NOTES:
• Use UL listed wire nuts of the appropriate size
to connect your household wiring to 16-gauge
dishwasher wiring.
• Insert wire ends into twist-on connector. Do
not pre-twist bare wire.
• Twist connector.
• Gently tug on wires to be sure both wires are
secured.
Ground
White
Tighten strain relief screws to secure the power cord.
7
Gently guide the wire nuts into the junction box then replace the
8
junction box cover making sure to not pinch the wires.
CONNECT POWER CORD
• Plug into a grounded 3 prong outlet.
• Do not remove the ground prong from the power
cord plug.
• Do not use an adapter.
• Do not use an extension cord.
• Failure to do so can result in death, fire or electrical
shock.
IMPORTANT: The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local codes and
ordinances. Recommended cord length is 54" to 64".
Confirm the power is turned off at the source.
1
Remove junction box cover. Retain for later use.
2
Install a UL listed/CSA approved strain relief.
3
Route power cord in the channel on the right-hand side of the
4
dishwasher base. Make sure the dishwasher is not resting on and/
or pinching the wire.
11
Black
WARNING
ELECTRICAL SHOCK HAZARD
Advertisement
Table of Contents
