Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
STEP 11: SECURE DISHWASHER
IMPORTANT: The dishwasher must be secured to adjacent cabinets
to keep it from tipping when the door is opened.
Follow the instructions to install mounting brackets in the manner
required for your installation method. You will secure the dishwasher
after it is connected to the utilities and moved into the opening.
EXCESSIVE WEIGHT HAZARD
• Use two or more people to move and install dishwasher.
• Failure to do so can result in back or other injury.
INSTALLATION TO ADJACENT CABINETS
Remove the plastic tub caps from the inside of the dishwasher tub.
1
Drive a wood screw through the hole in the side of the dishwasher
2
into the cabinet frame.
IMPORTANT:
• Drive the screws straight and flush. Protruding screw heads
will scratch the side of the dishwasher. This method is for
attaching the dishwasher to the side of the cabinet, and it
should be done when the countertop is made of granite or
other breakable materials.
• Do not overtighten side screws.
Reinsert the plastic tub caps.
3
Remove plastic
tub cap
Close dishwasher door and verify that gap between the countertop
4
and the top of the dishwasher door is at least
/
"
1
2
Countertop
(1.3 cm)
Dishwasher door
Reinstall the lower dish rack.
5
WARNING
Screw
Reinsert plastic
tub cap
1
/
" (0.64 cm).
4
STEP 12: PRE-TEST CHECKLIST
Review this list after installing your dishwasher to avoid charges
for a service call that is not covered by your warranty.
• Be sure power is OFF.
• Open door and remove all foam and paper packaging.
• Locate the Owner's Manual in the literature package.
• Read the Owner's Manual for operating instructions.
• Check door opening and closing. If door does not open and close
freely or tends to fall, check spring adjustments. See Step 1.
• Be sure wiring is secure under the dishwasher, not pinched or in
contact with door springs or other components. See Step 9.
• Check door alignment with tub. If door hits tub, level dishwasher.
See Step 10.
• Pull lower rack out, about halfway. Make sure it does not roll
back or forward on the door. If the rack moves, adjust leveling
legs. See Step 10.
• Check door alignment with cabinet. If door hits cabinet, reposition
or relevel dishwasher. See Step 10.
• Verify water supply and drain lines are not kinked or in contact
with other components. Contact with motor or dishwasher frame
could cause noise. See Step 8.
• Turn on the sink hot water faucet and verify water temperature.
Incoming water temperature must be between 120°F and 150°F.
A minimum of 120°F temperature is required for best wash
performance.
• Add 2 liters of water to the bottom of the dishwasher to lubricate
the pump seal.
• Turn on water supply. Check for leaks. Tighten connections if
needed.
• Remove protective film if present from the control panel and door.
14
Advertisement
Table of Contents
