Advertisement
8
6
Connect the positive & negative wires as appropriate.
18
19
7
Slide the Ethernet surge protective device back into its slot. Reattach the wing nut, securely tightening it to 5 to 7 inch-
pounds. Reconnect the RJ-45 connectors as appropriate. See Figure 4 for an illustration of a properly installed & connected
battery.
8
Insert the fuse into the fuse connector [8].
9
Reconnect AC power at the installation point.
Figure 4. Battery installed & connected
After installing the battery, verify that the device is operating correctly (see "Verifying operation" on page 9).
18
Negative -
19
Positive +
IL42-5150E
Advertisement
