Advertisement
CONNECTIONS
Connecting
the
AV
surround
processing
amplifier
VSP-333
Systems which include the VSP-333 comprise U.S., Canadian and multi-voltage models only. (The VSP-333 is not for sale in other regions).
FOR USE WITH VSP-333
me |
O
T
WITHOUT VSP-333
Cassette deck receiver
To VSP-333's
ysP-333
AC OUTLET
CD player
TO AMP
To remove, hold both sides
of the plug and pull out.
Push the plug in
straight.
aS
@ When connecting VSP-333, turn the power OFF of the unit and disconnect the power cord from the household electrical outlets.
® Connect the power cord of VSP-333 to the AC OUTLET of the unit. With a system where a CD player is installed, connect the power cord
-
of the CD player to the AC OUTLET of VSP-333.
® Make sure to set the selecting switch before turning the power ON. Do not switch it during operation of the unit.
To control a unit other than this receiver using the
remote control unit.
eal
@ In the case of a PIONEER equipment marked
§q/ which is
provided with a remote sensor, operate the equipment
by
aiming the remote contro! unit at the remote sensor on the
equipment.
@® For equipment
with the FSR mark, but without a remote
sensor,
operation
of the equipment
by facing the remote
control unit towards the remote sensor of the cassette deck
receiver possible with connection from the CONTROL
OUT
jack to the CONTROL
IN jack. Use a commercially available
cable with mini-plugs for the connection.
(i o—
=
| cima: aor
|
Cm
_®
coma
naa
As
iz]
[erence
CD player
Equipment with
the SR mark
{VSP-333, etc.)
Cassette deck
receiver
6
<ARB1246 >
CONNECTING THE MULTI-ROOM
REMOTE IN
TERMINAL
To the optional Multi-Room Remote control unit MR-100
° For details, see instruction manual for Multi-Room
Remote
control unit.
NOTE:
Be careful not to make the wrong connections for CONTROL OUT
(black) and MULTI-ROOM REMOTE IN (green).
Optional Muiti-Room
Remote control unit
MR-100
Muiti-Room
Remote
Advertisement
