Advertisement
CONNECTIONS
The U.S. and Canadian
models
do not have the adaptor and
ground terminals.
Australian model does not have AC OUTLET.
FM T-type
Te
ar)
antenna
Control
——,
LD player or
VCR etc.
CD player
Adaptor terminals:
AC OUTLET
(For Australian and Multi-voltage models)
Adaptor component
(Dynamic expander, etc.)
Antenna ground
Although
grounding
is not
necessary
for
reception,
it is
recommended for protection against damage from lightning for
an outdoor FM antenna.
Grounding
is recommended
as well to
help to reduce noise and hum.
NOTE:
Never make the ground connection to a gas pipe as sparks could
cause the gas to ignite.
NOTE ABOUT.SPEAKER CONNECTIONS
Speaker systems should have an impedance from 8Q to 16Q.
* Be sure that connections are secure. Check to make sure that
wires do not protrude from their terminals.
* Do not allow the speaker cords to become shorted. Otherwise
damage may result to your equipment.
* Do
not
attempt
to
simultaneously
connect
two
sets
of
speakers to a single side ( A or B }. When using two sets of
speakers, connect one set to side A and one set to side B.
Turntable PL-203AZ/PL-223AZ/PL-2232
When using PL-203AZ/PL-223AZ/
PL-223Z turntable
_-- When using a turntable
other than the above.
©
Speaker
@
system A
L channel
R channel
©
Speaker
@
system B
L channel
R channel
To cassette deck receiver's
To household electrical outlets
NOTE:
Do not remote the shorting bar when not connecting the adaptor
terminals. When the adaptor component is disconnect, reinsert
the shorting bar.
BEAT CUT switch
Set this switch to minimize beat when
beat
is
being
recorded
during
recordings of AM broadcasts or during
tape copying while an AM broadcast is
being received.
AC OUTLET SWITCHED 200W MAX
(U.S., Canadian and Multi-voltage models)
Power supplied through this outlet is turned on and off by this
equipment's POWER switch. Total electrical power consumption
of connected equipment should not exceed 200 W.
NOTE:
De not connect appliances with high power consumption such as
heaters, irons, or television sets to the AC OUTLET, in order to
avoid overheating or fire risk.
This can cause this equipment to malfunction.
BEAT CUT B =F
BEAT CUT A —
BEAT CUT SWITCH
5
<ARB1246>
Advertisement
