Advertisement
COPYING TAPES
REV MODE switch
Operation
RELAY
REC
Gne side is copied from Deck |
PLAY
=
to Deck Il.
REC
PLAY
Both sides are copied from
a)
Co
Deck | te Deck It.
3.
To perform a normal
copy while listening to playback, set
FUNCTION
switch
on the amplifier
to TAPE
and select
DOLBY
NR switch position.
Even if FUNCTION
switch is set to another position, tape
| copying will still proceed. The sound of the program source
| selected
by FUNCTION
switch
will be heard
through
the
| speakers.
4,
Press one of COPY MODE switches.
NORMAL:
for tape copying at normal speed while listening to
it.
HIGH: for tape copying at about twice normal speed.
5.
Press STOP switch ({) on either deck to stop the copying at
any time.
NOTE:
* If you are using a TV in the vicinity of the unit, noise will be
recorded, Either switch off the TV or move it away from the
unit.
° There is variation in actual tape length even among cassettes
of the same length label (C-60, C-90, etc.). Therefore, even if
the recording
tape is labeled as the same
length as the
playback tape, it is possible for the recording tape to end first
without recording all of the contents of the playback tape.
le
| MIC MIXING
_ (Multi-voltage model only}
| MIXING KNOW-HOW
Mixing involves combining the signals from two input sources {a
icrophone and a tape, for example)
SINGING ALONG WITH A PROGRAM
SOURCE
Operate after setting the MIC MIXING'level control to SOURCE.
| 1. Perform the preliminary operations on page 11.
i
| 2. Plug a microphone into the MIC jack.
_ 3. Adjust the volume to a suitable level.
/
4. Set the MIC MIXING level contro! to the center position.
i
|
If howling occurs (a high-pitched sound from the speakers), _
|
take the following steps.
(1) Move the mocrophone away from the speakers.
{2} Lower the volume.
5. Select the desired
program
source
using the
FUNCTION |
switches.
6. Start playback of the program source.
7. Adjust the overall volume.
|
8. Using the MIC MIXING level control, adjust the sound balance |
|
between the microphone and the program source.
| 9. Using along with the program using the microphone.
NOTES:
Recording of mixed sound is possible. Although the sound
from the speaker during playback of Deck | will be mixed
sound, recording to Deck If will be made tape sound of the |
Deck | only.
When not using the MIC MIXING function, be sure to set the
MIC
MIXING
level contro!
to SOURCE
and
remove
the
microphone plug from the MIC jack,
The
graphic
equalizer
does
not
affect
the
sound
of
microphone.
15
<ARB1246>
Advertisement
