Electrical System Requirements - Smeg BPW4260 User Manual

REAR
FRONT
15.4

ELECTRICAL SYSTEM REQUIREMENTS

WARNING
The electrical system to which the device is connected must comply with the regulations in force.
All electrical checks and system installation must be carried out to the proper standard by skilled staff
qualified to work on electrical systems.
The skilled staff are responsible for ensuring that the ground connection is in good working order.
CONNECTION TYPE
The standard version of the device is supplied without a plug, with a cable with insulated wire terminals.
The device's electrical connection must be made by means of a plug suitable for the cable and
appropriately rated for the device's electrical characteristics.
The plug must be supplied and fitted by the customer.
Industrial plugs (IEC 60309) are recommended; they are designed to function safely in difficult
environmental conditions and to prevent accidental disconnections. They can only be disconnected from
the socket if there is no power present.
CIRCUIT-BREAKER
A CIRCUIT-BREAKER must be installed for each device.
Circuit-breaker characteristics:
a. Multi-phase: must break all live conductors;
b. Easily accessible to the user;
c.
d. Located in close proximity to the device;
e.
The same characteristics are also required for the circuit-breaker on the device: never position objects so
that they obstruct access to it.
POWER SURGE PROTECTION DEVICE
These devices are fitted with power surge protection devices: however, a specific overload cutout suitably
rated to protect the equipment should still be installed for each device, considering the stated electrical
characteristics.
POWER CABLE REPLACEMENT
If damaged power supply cables have to be replaced, cables with the same characteristics and gauge as
the cables fitted in the factory must be used (the cables fitted are marked with their types and
characteristics). This replacement may only be made by authorised technical staff. Use genuine spare
parts.
User Manual
BPW1260 – BPW4260 top view
The positions of the RS232 and LAN port are marked
Easily operated (no tool must be required);
Clearly marked as the device circuit-breaker.
193909105 rev.04 BPW1260 – BPW4260 Page 105 – 107