Philips LPC2194 User Manual page 278

Philips Semiconductors
ARM-based Microcontroller
Table 213: ISP Return Codes Summary
Return
Code
0 CMD_SUCCESS
1 INVALID_COMMAND
2 SRC_ADDR_ERROR
3 DST_ADDR_ERROR
4 SRC_ADDR_NOT_MAPPED
5 DST_ADDR_NOT_MAPPED
6 COUNT_ERROR
7 INVALID_SECTOR
8 SECTOR_NOT_BLANK
9 SECTOR_NOT_PREPARED_FOR_WRITE_OPERATION
10 COMPARE_ERROR
11 BUSY
12 PARAM_ERROR
13 ADDR_ERROR
14 ADDR_NOT_MAPPED
15 CMD_LOCKED
16 INVALID_CODE
17 INVALID_BAUD_RATE
18 INVALID_STOP_BIT
19 CODE_READ_PROTECTION_ENABLED
Flash Memory System and Programming
Mnemonic
LPC2119/2129/2194/2292/2294
Command is executed successfully. Sent by ISP
handler only when command given by the host has
been completely and successfully executed.
Invalid command.
Source address is not on word boundary.
Destination address is not on a correct boundary.
Source address is not mapped in the memory map.
Count value is taken in to consideration where
applicable.
Destination address is not mapped in the memory
map. Count value is taken in to consideration where
applicable.
Byte count is not multiple of 4 or is not a permitted
value.
Sector number is invalid or end sector number is
greater than start sector number.
Sector is not blank.
Command to prepare sector for write operation was
not executed.
Source and destination data not equal.
Flash programming hardware interface is busy
Insufficient number of parameters or invalid
parameter.
Address is not on word boundary.
Address is not mapped in the memory map. Count
value is taken in to consideration where applicable.
Command is locked.
Unlock code is invalid.
Invalid baud rate setting.
Invalid stop bit setting.
Code read protection enabled. Available as of
Bootloader rev. 1.61
278
Preliminary User Manual
Description
May 03, 2004