Table of Contents
Advertisement
SSID
Subnet
Isolate LAN
Isolate Member
VLAN ID
PHY Mode
Security
Peer MAC Address
After finishing this web page configuration, please click OK to save the settings.
Set a name for VigorAP 1000C to be identified. Default settings are
DrayTek-LAN-A and DrayTek-LAN-B. When Enable 2 Subnet is
enabled, you can specify subnet interface (LAN-A or LAN-B) for each
SSID by using the drop down menu.
Choose LAN-A or LAN-B for each SSID. If you choose LAN-A, the
wireless clients connecting to this SSID could only communicate with
LAN-A.
Check this box to isolate the wireless connection from LAN. It can
make the wireless clients (stations) with remote-dial and LAN to LAN
users not accessing for each other.
Check this box to make the wireless clients (stations) with the same
SSID not access for each other.
Type the value for such SSID. Packets transferred from such SSID to
LAN will be tagged with the number.
If your network uses VLANs, you can assign the SSID to a VLAN on
your network. Client devices that associate using the SSID are grouped
into this VLAN. The VLAN ID range is from 3 to 4095. The VLAN ID is 0
by default, it means disabling the VLAN function for the SSID.
Data will be transmitted via HTMIX mode.
Each access point should be setup to the same PHY Mode for
connecting with each other.
Select WEP, TKIP or AES as the encryption algorithm.
Type 8~63 ASCII characters, such as 012345678..(or 64 Hexadecimal
digits leading by 0x, such as "0x321253abcde...").
Type the peer MAC address for the access point that VigorAP 902
connects to.
42
Advertisement
Table of Contents
