Table of Contents
Advertisement
CPE Settings
Periodic Inform
Settings
STUN Settings
After finishing this web page configuration, please click OK to save the settings.
URL/Username/Password – Such data must be typed according to
the ACS (Auto Configuration Server) you want to link. Please refer to
Auto Configuration Server user's manual for detailed information.
Test With Inform – Click it to send a message based on the event
code selection to test if such CPE is able to communicate with
VigorACS SI server.
Event Code – Use the drop down menu to specify an event to perform
the test.
Last Inform Response Time – Display the time that VigorACS server
made a response while receiving Inform message from CPE last time.
Such information is useful for Auto Configuration Server (ACS).
Enable– Check the box to allow the CPE Client to connect with Auto
Configuration Server.
SSL(HTTPS) Mode - Check the box to allow the CPE client to connect
with ACS through SSL.
On – Choose the interface (LAN-A or LAN-B) for VigorAP 1000C
connecting to ACS server.
Port – Sometimes, port conflict might be occurred. To solve such
problem, you might change port number for CPE.
Username/Password – Type the username and password that
VigorACS can use to access into such CPE.
The default setting is Enable. Please set interval time or schedule time
for the AP to send notification to VigorACS server.
Interval Time – Type the value for the interval time setting. The unit is
"second".
The default is Disable.
If you click Enable, please type the relational settings listed below:
Server Address – Type the IP address of the STUN server.
Server Port – Type the port number of the STUN server.
Minimum Keep Alive Period – If STUN is enabled, the CPE must send
binding request to the server for the purpose of maintaining the
binding in the Gateway. Please type a number as the minimum
period. The default setting is "60 seconds".
Maximum Keep Alive Period – If STUN is enabled, the CPE must send
binding request to the server for the purpose of maintaining the
binding in the Gateway. Please type a number as the maximum
period. A value of "-1" indicates that no maximum period is specified.
95
Advertisement
Table of Contents
