2. Align the M.2 NVMe SSD at an angle with the BOSS-N1 card carrier.
3. Insert the M.2 NVMe SSD until it is firmly seated in the BOSS-N1 card carrier.
4. Using the Phillips #1 screwdriver, secure the M.2 NVMe SSD on the BOSS-N1 card carrier with the M3 x 0.5 x 4.5 mm
screw.
Figure 146. Installing the M.2 NVMe SSD
5. Align and push the BOSS-N1 card carrier into the slot in the BOSS-N1 module.
6. Close the release latch to secure the BOSS-N1 card carrier.
Figure 147. Installing the BOSS-N1 card carrier
Next steps
1. If removed,
install the front
2. Follow the procedure that is listed in
Optional internal USB card
NOTE:
To locate the internal USB port on the system board, see the
bezel.
After working inside your
system.
System board jumpers and connectors
Installing and removing system components
section.
191