Dell PowerEdge T560 Installation And Service Manual page 179

Figure 131. Removing the tape backup unit
Next steps
Replace the tape backup unit
Installing the tape backup unit
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
4. If installed, remove the front
Steps
1. Align and slide the tape backup unit in the slot on the system.
2. Using a Phillips #2 screwdriver, secure the tape backup unit to the system.
or install the tape backup unit
Safety instructions.
Before working inside your system
bezel.
blank.
.
Installing and removing system components 179