Installing the front PERC module
Prerequisites
1. Follow the safety guidelines listed in
Safety
instructions.
2. Follow the procedure that is listed in
Before working inside your system
.
3. Disconnect all the cables connected to the front PERC module.
Steps
1. Align the connectors and guide slots on the front PERC module with the connectors and guide pins on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 98. Installing the front PERC module to the 3.5-inch drive backplane
152
Installing and removing system components