Battery; Charging - Honeywell EDA50-211 User Manual

Chapter 1: Product Features of ScanPal Series EDA50-X11 Terminal

Battery

EDA50-X11 uses 3.8V rechargable lithium ion battery as its main power supply. The
battery capacity is 15.2 watt/hour. Battery life is influenced by many factors, such as:
screen brightness, the length of time before the screen automatically go to sleep, input
configurations, extreme temperature and using behaviors, etc.
Honeywell suggests you to keep the battery charged to avoid data loss. Change battery only
after switching off the device as per normal. Switch on the device after completing change
of battery.
If you need to buy a replacable battery, please contact regional resellers.
Warning: Improper use of the battery of this device can cause a fire or chemical burns.
Please don't disassemble the battery or heat it to 100 °C (212 °F) and above, or
incinerate the battery. Make sure waste batteries are properly disposed. Keep out of
reach of the children.
We would recommend using only Honeywell's lithium battery; any damage caused by
use of non-Honeywell battery is not covered by warranty.

Charging

Before using EDA50-X11, you need to make sure the battery (model number
BAT-EDA50K) is fully charged. You can charge the battery before or after installing it to
EDA50-X11. It will take about 5 hours for the battery to be fully charged using original
quad charger (cradle charger or otherwise).
We would recommend using Honeywell's original charger; any damage caused by use
of non-Honeywell charger is not covered by warranty
6
User Guide for ScanPal Series Terminal