Makita XHU10SM1 Instruction Manual page 11

12. Slide the guide bar as shown in the figure.
Fig.16
13. Place the metal sleeves and the flat washer, then
tighten the bolts.
3
Fig.17
► 1 . Metal sleeve 2. Flat washer 3. Bolt
1
2
3
14. Attach the cover, and then tighten 6 screws.
1
Fig.18
► 1 . Screw 2. Cover
Installing or removing the chip
receiver
Optional accessory
CAUTION:
When installing or removing the
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
NOTICE:
The blade cover cannot be installed if
the chip receiver is installed on the tool. Before
carrying or storing the tool, uninstall the chip
receiver, and then install the blade cover to avoid
exposure of the shear blades.
NOTICE:
Be sure to remove the blade cover
before installing the chip receiver.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier. It can be installed on
either side of the tool.
1. Align the holes on the chip receiver with the
screws on the shear blades.
1
Fig.19
► 1 . Screw
11 ENGLISH
2