Honeywell NOTIFIER NFS2-3030 Programming Manual page 100

Releasing Applications
How to Program a ULC Release Circuit
NOTE: A ULC Release Circuit with this Type Code requires the following selections: a Releasing
Zone; an output circuit mapped to the same Releasing Zone; Switch Inhibit ; Non-Silenceable; No
Walk Test.
The following contains information needed to program a ULC Release Circuit for an SLC output
.
module
Description An SLC output module used to activate a releasing solenoid or other releasing
device. Multiple outputs with the
Releasing Zone. When the Releasing Zone activates, all outputs with the
also activate at the same time. A ULC Release Circuit activates when:
• An initiating device programmed to the same Releasing Zone activates (two devices if using
the Cross Zone option)
• The Delay Timer for the Releasing Zone (if used) expires
• No Abort Switch for the Releasing Zone (if used) is active
A ULC Release Circuit —and all wiring to the release device—is fully supervised and usable with
power-limited energy cable.
Program Select an SLC output module to use for a ULC Release Circuit. While programming the
point (refer to the Point Programming section of this manual for instructions),
1. Select the
2. Enter the number of the desired Releasing Zone into the module's zone map. The releasing
zone must be fully programmed (refer to Section 3.4.4, "Releasing Zone", on page 50).
Example A programming example of a control module programmed as a ULC Release Circuit
for Releasing Zone ZR05.
100
REL CKT ULC
Type Code,
REL CKT ULC
Monitor
Detector
Module
Type Code
REL CKT ULC
SLC
SLC
output
output
module
module
A
Figure B.14 Output Module Configured as a ULC Release Circuit
Type Code can also be mapped to the same
Detector
ZR05
SLC
output
module
B
NFS2-3030 Programming Manual — P/N 52545:A 11/29/2005
Abort Switches
Type Code
REL CKT ULC
Detector
Type Code
REL CKT ULC
SLC
output
module