Makita PJ7000 Instruction Manual page 5

1
► 1. Fence 2. Lock lever 3. Angle scale 4. Tighten
5. Loosen
When the fence is set at 90°, both the distance from
the center of the blade thickness to the fence and the
distance from the center of the blade thickness to the
bottom of the blade cover are 10 mm (0.4").
2
3
10mm
10mm
► 1. Lock lever 2. Pointer 3. Angle scale 4. Center of
blade thickness 5. Blade cover
Set plate
Use the set plate as shown in the figures when cutting
slots in thin workpieces.
2
5:
3
4mm
4
10mm
10mm
6mm
► 1. Lock lever 2. Pointer 3. Angle scale 4. Set plate
5. Thickness of set plate 6. Center of blade thick-
ness 7. Blade cover
5
4
3
1
4
6
2
► 1. Set plate
Switch action
► 1. Slide switch
5
CAUTION:
• Before plugging in the tool, always check to
see that the slide switch actuates properly and
returns to the "OFF" position when the rear of
the slide switch is depressed.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
1
To start the tool, slide the slide switch toward the "I
(ON)" position. For continuous operation, press the
front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
ASSEMBLY
7
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
5 ENGLISH
1
1