Angle Guide; Functional Description - Makita PJ7000 Instruction Manual

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting the depth of groove
3
2
► 1. Pointer 2. Stopper 3. Adjusting screw 4. Rubber
spike
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence
between the sizes marked on the stopper and the bis-
cuit size. Fine adjustments to the grooving depth can be
made by turning the adjusting screw after loosening the
hex nut. This may become necessary after the blade
has been resharpened a few times.
Size on stopper 0 10
Biscuit size 0 10
8 mm 10 mm
Depth of groove
(0.3") (0.4")
* With the rubber spikes removed.
1
4
20 S D MAX
20 - - -
12.3mm 13 mm 14.7mm 20 mm
(0.48") (0.51") (0.58") (0.8")

Angle guide

The angle guide height can be moved up and down to
adjust the position of the blade in relation to the top of
the workpiece.
6
7
2
► 1. Lock lever 2. Angle guide 3. Knob 4. Scale
5. Pointer 6. Tighten 7. Loosen
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance
from the top of the workpiece to the center of the blade
thickness.
1
► 1. Knob 2. Down 3. Up 4. Center of blade thickness
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
NOTE:
• Remove the angle guide according to the need
of your work when using the tool with the angle
of the fence adjusted to other than 0°. When you
need to use the angle guide under the above
condition, be sure to adjust the depth of groove
to get a proper depth.
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
* angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
4 ENGLISH
1
5
3
4
2
3
4