Table of Contents
Advertisement
Available languages
Available languages
2.
Turn the lever toward the attachment.
Fig.8
► 1 . Lever
3.
Align the pin with the arrow mark on the power
unit. Insert the pipe until the release button pops up.
Make sure that the position line is on the tip of the arrow
mark on the power unit, and the arrow mark on the
power unit and the arrow mark on the pipe are facing
each other.
Fig.9
► 1 . Release button 2. Arrow mark on the power unit
3. Pin 4. Position line 5. Arrow mark on the pipe
4.
Turn the lever toward the power unit.
1
Fig.10
► 1 . Lever
1
1
2
3
4
5
Make sure that the surface of the lever is parallel to the
pipe.
NOTICE:
Do not tighten the lever without the
attachment pipe inserted. Otherwise the lever may
tighten the entrance of the drive shaft too much and
damage it.
To remove the pipe, turn the lever toward the attach-
ment and pull the pipe out while pressing down the
release button.
Fig.11
Fig.12
► 1 . Release button 2. Lever 3. Pipe
Removing or attaching the blade
cover
Release the latches of the blade cover by pulling them,
and then open the blade cover.
Fig.12
► 1 . Latch
When attaching the blade cover to the shear blades,
make sure that the blade cover is closed and both
latches are fixed securely.
6 ENGLISH
1
2
1
3
Advertisement
Table of Contents
