Proper Use Of Refrigerator; Installation; Door Handle Installation; Reversing The Door Swing - Honeywell H18TFW User Manual

2 PROPER USE OF REFRIGERATOR

2.1 Installation

When selecting a position for your unit you should make sure the floor is flat and
firm, and the room is well ventilated.
Avoid placing your unit near a heat source.
Avoid direct sunlight as it may increase the electrical consumption.
Extremely cold temperatures may also cause the unit not to perform properly. This
unit is not designed for use in a garage or outdoor installation.
When installing the unit, ensure that 3 inch of free space is left at both sides, 1
inch at the rear and 1 inch at the top of the unit. This will allow cold air to circulate
around the refrigerator and improve the efficiency of the cooling process.

2.2 Door Handle Installation

Note: The refrigerator must be disconnected from the source of electrical supply
before attempting the installation of accessory.
01 Take out the two cross screws, and install them into the door holes; turn the
screws till to the bottom
02 Aim at screws to install the handle
03 Place the screws in the hole at the side of the handle and turn the screws until
they are tight
04 Place screw caps on the screws

2.3 Reversing the Door Swing

01 Please prepare the following tools in advance:
a. Tools: cross screwdriver, Allen key and straight screwdriver
b. Parts: refer to the components and parts in the accessory pouch
2