Table of Contents
Advertisement
07 Push water inlet tube into small hole on the back of the refrigerator. Rotate
while inserting tube until flat surface of inlet tube is tight against the back of
the refrigerator.
08 Push plastic water supply tubing into water inlet tube as far as it will go
and manually tighten nylon compression nut onto threaded end of inlet tube.
Tighten another one half turn with a wrench.
09 Install adjustable leveling bracket on the bottom of the ice maker with
screw. DO NOT tighten bracket.
10 Put two ice maker mounting screws into freezer wall. Turn each screw five
times clockwise.
11 With ice maker in one hand, plug ice maker connector into connector
mounted on top of the freezer panel. Make sure the connection is tight.
Wiring Harness
Connector
Screw
10
Leveling
Bracket
Advertisement
Table of Contents
