Makita HR2650 Instruction Manual page 10

Hammering only
For chipping, scaling or demolition operations, rotate
the action mode changing knob to the
bull point, cold chisel, scaling chisel, etc.
Fig.9: 1. Hammering only
Adjusting the nozzle position
button, and then release the button at the desired
position.
Fig.10: 1. Guide 2.
NOTE:
Adjusting the drilling depth
depth.
Fig.11: 1.
Torque limiter
NOTICE:
As soon as the torque limiter actuates,
switch off the tool immediately.
vent premature wear of the tool.
NOTICE:
Drill bits such as hole saw, which tend
to pinch or catch easily in the hole, are not appro-
priate for this tool.
the torque limiter to actuate too frequently.
output shaft. When this happens, the drill bit will stop
turning.
Hook
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
For HR2661
Fig.12: 1. Hook
the open position. When not in use, always lower hook
until it snaps into the closed position.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Side grip (auxiliary handle)
CAUTION:
symbol. Use a
safe operation.
CAUTION:
secured.
Fig.13: 1. Side grip
Grease
Coat the shank end of the drill bit beforehand with a
small amount of grease (about 0.5 - 1 g).
ger service life.
-
Installing or removing drill bit
Clean the shank end of the drill bit and apply grease
before installing the drill bit.
Fig.14: 1. Shank end 2. Grease
it in until it engages.
-
drill bit is securely held in place by trying to pull it out.
Fig.15: 1. Drill bit
way and pull the drill bit out.
Fig.16: 1. Drill bit 2. Chuck cover
Chisel angle (when chipping,
scaling or demolishing)
change the chisel angle, rotate the action mode chang-
angle.
Fig.17: 1.
Rotate the action mode changing knob to the
place by turning it slightly.
Depth gauge
uniform depth. Loosen the side grip and insert the depth
gauge to the desired depth and tighten the side grip
Fig.18: 1. Hole 2. Depth gauge
NOTE: Make sure that the depth gauge does not
touch the main body of the tool when attaching it.
10 ENGLISH
Always use the side grip to ensure
After installing or adjusting the
-
-
sym-