General Information; Intended Use; Parts Description - Makita AC001G Instruction Manual

Cordless air compressor
Hide thumbs Also See for AC001G:
Table of Contents

Advertisement

12. The contained lithium-ion batteries are subject
to the Dangerous Goods Legislation require-
ments.
aging and labeling must be observed.
national regulations.
battery in such a manner that it cannot move
13. When disposing the battery cartridge, remove
it from the tool and dispose of it in a safe
place. Follow your local regulations relating to
disposal of battery.
14. Use the batteries only with the products
15. If the tool is not used for a long period of time,
the battery must be removed from the tool.
16. During and after use, the battery cartridge may
take on heat which can cause burns or low
temperature burns. Pay attention to the han-
dling of hot battery cartridges.
17. Do not touch the terminal of the tool imme-
diately after use as it may get hot enough to
cause burns.
18. Do not allow chips, dust, or soil stuck into the
terminals, holes, and grooves of the battery
cartridge.
19. Unless the tool supports the use near
high-voltage electrical power lines, do not use
the battery cartridge near a high-voltage elec-
trical power lines.
20. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
have been altered, may result in the battery bursting
charger.

Parts description

Fig.1
1
5
Regulator
9
CAUTION:
Always use accessories and attachments recommended for use with Makita product. Not
doing so may cause personal injury. Accessories and attachments must be used for its original purpose. If
you need any assistance, ask your local Makita Service Center.
-
Installing the batteries to
-
2
Battery cartridge
6
10
Tips for maintaining maximum
battery life
1.
Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
-
less tool power.
2.
Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3.
Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4.
When not using the battery cartridge, remove
it from the tool or the charger.
5.
Charge the battery cartridge if you do not use
it for a long period (more than six months).
-
INTRODUCTION

General information

Intended use

WARNING:
Never use compressor for appli-
cations other than to operate a properly rated
nailer or stapler.
WARNING:
Use the pressure gauge only for a
reference. Check the air pressure using calibrated
objects.
3
Carrying handle
7
Air outlet (Rc 1/4)
11
Drain valve
8 ENGLISH
-
4
8
12
Air tank

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ac001gz

Table of Contents