Cisco 8800 Series Manual page 3

Cisco IP Phone Accessories
Note
Connect the Footstand
If your phone is placed on a table or desk, connect the footstand to the back of the phone.
Procedure
Step 1 Insert the connectors into the slots.
Step 2
Press the footstand until the connectors snap into place.
Step 3 Adjust the angle of the phone.
Secure the Phone with a Cable Lock
You can secure your phone with a laptop cable lock up to 20 mm wide.
Procedure
Step 1
Take the looped end of the cable lock and wrap it around the object to which you want to secure your phone.
Step 2 Pass the lock through the looped end of the cable.
Step 3
Unlock the cable lock.
Step 4 Press and hold the locking button to align the locking teeth.
Step 5
Insert the cable lock into the lock slot of your phone and release the locking button.
Step 6 Lock the cable lock.
1. If you connect your headset to the phone with the Y-cable (RJ-9 connector and AUX connector) , make
sure that you enable Electronic HookSwitch Control in the Audio Volume area from Voice > User tab
on the phone administration web page.
2. When you use the Electronic Hookswitch (EHS):
• The EHS connects to the Cisco IP Phone 8811, 8841, and 8845 with the auxiliary port.
• The EHS connects to the Cisco IP Phone 8851, 8861, and 8865 with the auxiliary port, the USB port,
or with Bluetooth.
Connect the Footstand
Cisco IP Phone Accessories
3