Installation; Safety; Appliance Description - AEG MTD 350 Operation And Installation Manual

Installation - for contractors

INSTALLATION

7. Safety

Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
Material losses
!
Observe the max. permissible inlet temperature.
Higher temperatures may damage the appliance. You
can limit the inlet temperature by means of a central
thermostatic valve.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.
The specific electrical resistance of the water must not fall
below that stated on the type plate. In a linked water net-
work, factor in the lowest electrical resistance of the water
(see chapter "Specification / Data table"). Your water sup-
ply utility will advise you of the specific electrical water
resistance or conductivity.
28

8. Appliance description

8.1 Standard delivery
The following are delivered with the appliance:
º Sieve inside the cold water inlet
º Special aerator
º Connection hose 3/8, 500 mm long, with gaskets*
º Tee 3/8*
*for the connection as pressure-tested appliance
8.2 Accessories
Special aerator
º for MTD 350 and MTD 440
º for MTD 570 and MTD 650
Note
Fitting the special aerator supplied provides an op-
timum water jet.
Non-pressurised taps
º AHu 40 MTH Twin lever basin tap
º AHEu 40 MTH Mono lever basin tap