Mounting Bracket Installation; Mounting Bracket; Canopy - Honeywell WICKER PARK Manual

3. Turn off the circuit breakers and wall switch leading
to the fan wire leads (Fig. 3).
!
WARNING
Failure to disconnect the power supply prior to
installation may result in serious injury or death.
4. Loosen all four mounting bracket screws and
completely remove the two mounting bracket
screws from the round holes of canopy. Set aside
for later use. Detach mounting bracket from canopy
(Fig. 4).

Mounting Bracket

Screw
5. Secure the mounting bracket to the outlet box using
screws, spring washers, and flat washers provided
with the outlet box (not included) (Fig. 5).
Note: It is very important to use proper hardware
when installing the mounting bracket, as it supports
the fan.
Important: If using angle mount, ensure the open
end of the mounting bracket is installed facing the
peak of the ceiling.

MOUNTING BRACKET INSTALLATION

!
Fig. 3
Fig. 4

Canopy

Fig. 5
6
Mounting Mounting
Bracket Bracket
Screws