Mounting Bracket Installation - Honeywell 10288 Manual

4. Turn off the circuit breakers and wall switch leading
to the fan wire leads.
!
WARNING
Failure to disconnect the power supply prior to
installation may result in serious injury or death.
5. Loosen all four pre-assembled mounting bracket
screws, then completely remove the two mounting
bracket screws from the round holes of canopy. Set
aside for later use. Detach mounting bracket from
canopy. (Fig. 5).
Mounting Bracket
Screw
6. Secure the mounting bracket to the outlet box using
screws, spring washers, and flat washers provided
with the outlet box (not included) (Fig. 6).
Note: It is very important to use proper hardware
when installing the mounting bracket, as it supports
the fan.
Important: If using the angle mount, ensure the
open end of the mounting bracket is installed facing
the higher point of the ceiling.

MOUNTING BRACKET INSTALLATION

!
Fig. 4
Fig. 5
Canopy
Fig. 6
6
Mounting Mounting
Bracket Bracket
Screws