Toshiba Infinia 7130 Series Maintenance Manual page 128

Connecting and Disconnecting LED and Switch Cables
Switch and LED cables are stranded cables (two) that are attached to the computer and
connect to the system. These cables use normal pin connectors (not keyed) that are labeled
with the name of the switch or LED that the cable connects to. For instance, the connector
on the cable coming from the reset switch is labeled Reset SW while the connector on the
cable coming from the hard drive is labeled H.D.D. LED. See Figure 4-5.
NOTE: The Power LED connector attaches to the pins labeled SLEEP LED on
the system board.
Switch and LED cables connect to sockets on the system board. These sockets are labeled
with the name of the switch or LED that the corresponding cable connects to. For instance,
the socket intended for the Reset SW cable is labeled Reset.
Connecting and Disconnecting Cable Connectors
The Infinia™ uses two types of cable connectors: normal pin connectors and latch connectors.
To connect and disconnect these connectors, perform the following general instructions and
refer to Figure 4-6.
Disconnect normal pin connectors by grasping the connector and carefully pulling
the connector from its socket.
Connect normal pin connectors by aligning the holes on the cable's connector
with the pins on the corresponding socket, then pushing the connector into the
socket.
Disconnect latch connectors by pressing the latch on the connector and carefully
pulling the connector from its socket.
Connect latch connectors by aligning the holes on the cable's connector with the
pins on the corresponding socket, then pushing the connector into the socket until
the latch catches.
Gently pull on cable connectors to make sure they are secure.
Infinia™ Series Maintenance Manual --------------------------------------------------------- 4-121
Figure 4-5 Switch and LED Cables