Honeywell UDC2800 Product Manual page 130

Function Selections or Range
Prompt of Setting
Switchover Value in
Value 2/3 engineering units
within PV or SP
range limits
Switchover Value in
Value 3/4 engineering units
within PV or SP
range limits
Local SP
Source
1 Local SP
2 Local SP
3 Local SP
4 Local SP
Parameter Definition
ATTENTION: Only appears when PID
Sets is configured for 2 Sets PV
Switchover, 2 Sets SP Switchover, 4 Sets
PV Switchover, or 4 Sets SP Switchover.
Automatic Switchover Value
Process Variable or Setpoint at which the
controller will switch from Tuning Constant
Set #2 to Set #3.
ATTENTION: Only appears when PID
Sets is configured for 4 Sets PV
Switchover, or 4 Sets SP Switchover.
Automatic Switchover Value
Process Variable or Setpoint at which the
controller will switch from Tuning Constant
Set #3 to Set #4.
ATTENTION: Only appears when PID
Sets is configured for 4 Sets PV
Switchover, or 4 Sets SP Switchover.
Local Setpoint Source
determines how many local setpoints are
enabled.
The setpoint entered from the keyboard.
This selection lets you switch between two
local setpoints using the Function key under
the main screen.
This selection lets you switch between three
local setpoints using the Function key under
the main screen.
This selection lets you switch between four
local setpoints using the Function key under
the main screen.
Chapter 4 - Configuration
- This is the value of
- This is the value of
- This selection
130