Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing driver bit or
socket bit
12 mm
(15/32")
Use only bits that has inserting portion shown in the
figure.
1
► 1. Bit 2. Sleeve
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
•
If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
•
After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
9 mm
(3/8")
2
Hook (Optional accessory)
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
CAUTION:
•
Do not cover vents, or it may cause overheating
and damage to the tool.
► 1. Vent
6 ENGLISH
1
2
3
1
Advertisement
Table of Contents
