NETGEAR HE102 User Manual page 23

Wireless LAN Configuration Parameters
CONFIGURATION DESCRIPTION
Enter a 32-character (maximum) service set ID in this field; the
characters are case sensitive. When in infrastructure mode, this field
defines the service set ID (SSID). The SSID assigned to the wireless
SSID (Service Set ID)
node is required to match the access point SSID in order for the wireless
node to communicate with the access point.
Default: Wireless
The unique name represents the access point.
System Name
Default:
Shows the current channel and frequency in use. The wireless channel
Channel/Frequency in use will be between 36 and 64 or 42, 48, 54 with turbo mode enabled.
Default: 52 (non-turbo), 42 (Turbo)
Enabling turbo mode allows the wireless node to transmit or receive at a
Turbo Mode higher rate, up to 72 Mbps.
Default: Disable
Shows the available transmit data rate of the wireless network. The
possible data rates supported are: 54 Mbps, 48 Mbps, 36 Mbps, 24
Data Rate Mbps, 18 Mbps, 12 Mbps, 9 Mbps, and 6 Mbps. It can go up to 72 Mbps
if the turbo mode is enabled.
Default: Best
Set the transmit signal strength of the HE102. The options are
"full", "half", "quarter", "eighth", "and "min". Decrease the transmit power
Transmit Power
if more than one AP is co-located using the same channel frequency.
Default: Full
Specifies the Beacon Interval value. Enter a value in between 20 to
Beacon Interval 1000.
Default: 100
The Delivery Traffic Indication Message. Speechifies the data beacon
DTIM rate between 1 and 16384.
Default: 1
21