Upgrading The Modem's Firmware; How To Upgrade The Modem Firmware - NETGEAR DM111PBL Reference Manual

1. To erase the configuration, from the Maintenance menu Settings Backup link, click the Erase
button on the screen.
2. The modem will then reboot automatically.
After an erase, the modem's password will be password, the LAN IP address will be
192.168.0.1, and the modem's DHCP client will be enabled.
Note: To restore the factory default configuration settings without knowing the login
password or IP address, you must use the Default Reset button on the rear
panel of the modem; see

Upgrading the Modem's Firmware

The software of the ADSL2+ Modem is stored in FLASH memory, and can be upgraded as new
software is released by NETGEAR.
Upgrade files can be downloaded from NETGEAR's Web site. If the upgrade file is compressed
(.ZIP file), you must first extract the binary (.BIN or .IMG) file before uploading it to the modem.

How to Upgrade the Modem Firmware

Note: NETGEAR recommends that you back up your configuration before doing a
firmware upgrade. After the upgrade is complete, you may need to restore your
configuration settings.
1. Download and unzip the new software file from NETGEAR.
The Web browser used to upload new firmware into the modem must support HTTP uploads.
NETGEAR recommends using Microsoft Internet Explorer 5.0 or above.
Managing Your Modem
DM111P ADSL2+ Ethernet Modem Reference Manual
Figure 2-4 on page
v1.0, August 2006
2-4.
3-3