The Modem's Front Panel - NETGEAR DM111PBL Reference Manual

The Modem's Front Panel

The DM111P ADSL2+ Ethernet Modem front panel shown below contains status LEDs.
1
Figure 1-1
You can use the LEDs to verify various conditions.
front panel of the modem. These LEDs are green when lit.
Table 1-1. LED Descriptions
Label Activity
Solid On (Green)
Blinking (Green)
1. Power
Solid On (Red)
Off
Solid On (Green)
2. LAN
Off
Solid On (Green)
Blinking (Green)
3. ADSL
Off
Solid On (Green)
Off
4. Internet
Introduction
DM111P ADSL2+ Ethernet Modem Reference Manual
3
2
Table 1-1
Description
Power is supplied and the modem in its normal operating mode.
Firmware update is in progress
Self test is in progress or self-test failed
Power is not supplied to the modem.
A device is connected to the yellow Ethernet port.
No device is connected to the yellow Ethernet port.
The modem is synchronized with your service provider's DSLAM.
The modem is synchronizing with your service provider;s DSLAM.
No ADSL link detected.
Internet connection is active.
Modem is powered off, or is in bridged mode, or there is no ADSL
connection.
v1.0, August 2006
4
lists and describes each LED on the
1-5