NETGEAR RangeMax DG834PN Reference Manual page 85

Reference Manual for the DG834PN RangeMax
a. Click the Edit button to open the Edit Menu, shown in
Figure 6-6
b. Type a route name for this static route in the Route Name box under the table.
This is for identification purpose only.
c. Select Private if you want to limit access to the LAN only.
The static route will not be reported in RIP.
d. Select Active to make this route effective.
e. Type the Destination IP Address of the final destination.
f. Type the IP Subnet Mask for this destination.
If the destination is a single host, type 255.255.255.255.
g. Type the Gateway IP Address, which must be a router on the same LAN segment as the
router.
h. Type a number between 1 and 15 as the Metric value.
This represents the number of routers between your network and the destination. Usually,
a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
4. Click Apply to have the static route entered into the table.
Advanced Configuration
v1.0, November 2005
TM
ADSL Modem Wireless Router
Figure 6-6.
6-11