Default Factory Settings - NETGEAR KWGR614 Reference Manual

54Mbps Wireless Router Model KWGR614 Reference Manual
• Manual method. These values are not case sensitive. For 64-bit WEP, enter 10 hex
digits (any combination of 0-9 or a-f). For 128-bit WEP, enter 26 hex digits.
Key 1: ___________________________________
Key 2: ___________________________________
Key 3: ___________________________________
Key 4: ___________________________________
• If WPA-PSK or WPA2-PSK Authentication is Used:
– Passphrase: ______________________________ These characters are case sensitive.
Enter a word or group of printable characters. When you use WPA-PSK, the other devices
in the network will not connect unless they are set to WPA-PSK as well and are configured
with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the
network will not connect unless they are set to WPA2-PSK and are configured with the
correct Passphrase.
Use the procedures described in the following sections to configure the KWGR614. Store this
information in a safe place.

Default Factory Settings

When you first receive your KWGR614, the default factory settings are in effect as shown below.
You can restore these defaults with the Factory Default Restore button on the rear panel. After you
install the 54Mpbs Wireless Router, use the procedures below to customize any of the settings to
better meet your networking needs.
Wireless Access List (MAC Filtering)
2-8
FEATURE
Wireless Router Radio
SSID broadcast
SSID
802.11b/g RF Channel
Mode
Authentication Type
WEP
DHCP Server
DHCP range
v1.2, September 2006
DEFAULT FACTORY SETTINGS
Enabled
All wireless stations allowed
Enabled
NETGEAR
6
802.11b/g/g and b
Automatic
Disabled
Enabled
192.168.1.2 to 192.168.1.254
Wireless Configuration