Makita 8413D Instruction Manual page 12

1
2
3
1. Teeth
2. Grip base
3. Side grip
1. Sleeve
1
1. Bit
2. Bit holder
1
1. Depth rod
2. Clamp screw
12
Installing side grip (auxiliary handle)
002427
Always use the side grip to ensure operating safety. Install
the side grip so that the teeth on the grip fit in between the
protrusions on the tool barrel.
Then tighten the grip by turning clockwise at the desired
position. It may be swung 360° so as to be secured at any
position.
Installing or removing driver bit or drill bit
002431
Turn the sleeve counterclockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go. Turn the sleeve
clockwise to tighten the chuck.
1
To remove the bit, turn the sleeve counterclockwise.
When not using the driver bit, keep it in the bit holders. Bits
002432
45 mm (1-3/4") long can be kept there.
2
Adjustable depth rod
002437
The adjustable depth rod is used to drill holes of uniform
depth. Loosen the clamp screw, set to desired position, then
tighten the clamp screw.
2