Makita RP1803F Instruction Manual page 11

2.
Secure the templet to the workpiece. Place the
tool on the templet and move the tool with the templet
guide sliding along the side of the templet.
1
2
3
4
5
(X)
Fig.23
► 1. Router bit 2. Base 3. Base plate 4. Templet
5. Workpiece 6. Templet guide
NOTE: The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the router bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - router bit diameter) / 2
Trimmer guide
Optional accessory
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
1
Fig.24
► 1. Trimmer guide
Install the trimmer guide on the guide holder using the clamp-
ing screw (D). Insert the guide holder into the holes in the tool
base and tighten the clamping screw (A). To adjust the distance
between the router bit and the trimmer guide, loosen the clamping
screw (D) and turn the fine adjusting screw (1.5 mm per turn).
6
When adjusting the guide roller up or down, loosen the clamping
screw (C). After adjusting, tighten all the clamping screws securely.
1
2
3
Fig.25
► 1. Guide holder 2. Fine adjusting screw 3. Clamping
screw (D) 4. Clamping screw (C) 5. Guide roller
6. Clamping screw (A)
When cutting, move the tool with the guide roller riding
the side of the workpiece.
Fig.26
► 1. Router bit 2. Guide roller 3. Workpiece
Dust nozzle sets
Use the dust nozzle for dust extraction.
1. Install the dust nozzle on the tool base using the
thumb screw so that protrusion on the dust nozzle fit to
the notch in the tool base.
Fig.27
► 1. Dust nozzle 2. Thumb screw
11 ENGLISH
4
3
2
1
6
5
1
2