Board Settings (Euromap67 Board); Installation (Euromap67 Board) - Epson RC700 Series Original Instructions Manual

EUROMAP connecter
(CN4) Pin No.
A4
C4
A5
A6
A7
A8
A9
B2
B3
B4
B5
B6
B7
B8
C5
C6
C7
C8
C9
*1: DO NOT input a voltage which exceeds 24V. Board may get damage and burnout.

16.8.2 Board Settings (EUROMAP67 Board)

Configure DIP-Switch (SW1) to enable the robot Controller to recognize the
EUROMAP67 board.

16.8.3 Installation (EUROMAP67 Board)

For the install procedure, refer to the RC700 series Maintenance Manual.
RC700 Series Rev.3
Reserved for future use by EUROMAP
Not fixed by EUROMAP, manufacturer
dependent
Enable mold closure
Enable full mold opening
Reserved for future use by EUROMAP
Supply from IMM
Robot operation mode
Enable ejector back
Enable ejector forward
Enable movement of core pullers 1 to position 1
Enable movement of core pullers 1 to position 2
Enable movement of core pullers 2 to position 1
Enable movement of core pullers 2 to position 2
Not fixed by EUROMAP, manufacturer
dependent
Reserved for future use by EUROMAP
Reserved for future use by EUROMAP
Not fixed by EUROMAP, manufacturer
dependent
Supply from IMM
Board Appearance
SW1
Signal Name
Switch setting: Setup the DSW1
1 st board
Functions 16. Option Slots
Note
I/O Input
I/O Input
I/O Input
I/O Input
24V DC
(IMM → Robot)
I/O Input
I/O Input
I/O Input
I/O Input
I/O Input
I/O Input
I/O Input
I/O Input
I/O Input
I/O Input
I/O Input
0V (IMM → Robot)
2 nd board
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
193