Setup & Operation 14. Option Slots
14.8.2 Board Settings (EUROMAP67 Board)
Configure DIP-Switch (SW1) to enable the robot controller to recognize the
EUROMAP67 board.
Board Appearance
SW1
14.8.3 Installation (EUROMAP67 Board)
(1) Turn OFF the Controller.
(2) Disconnect the power plug.
(3) Remove the Top Panel. (Mounting screw ×6)
(4) Insert the EUROMAP67 board into either slots 1, 2 or 3.
(5) Use four screws to fix the EUROMAP67 board in place.
108
(Slot 4 cannot be used.)
First, temporarily fasten the four screws in place. Next, fully tighten screws located
diagonally opposite each other.
Take care not to damage the thread holes when doing so.
Switch setting: Setup the DSW1
st
1
board
nd
2
board
RC700 / RC700-A Rev.23