Precaution; Port - Epson RC700 Series Original Instructions Manual

7.2 Precaution

When connecting the development PC and the Controller, make sure of the following:
- Connect the development PC and the Controller with a 5 m or less USB cable.
- Make sure that no other devices except the development PC are used for development
- Use a PC and USB cable that supports USB2.0 HighSpeed mode to operate in USB2.0
- Do not pull or bend the cable strongly.
- Do not allow unnecessary strain on the cable.
- When the development PC and the Controller are connected, do not insert or remove
7.3 PC and Controller Connection Using
Development PC Connection USB Port
Connection of the development PC and the Controller is indicated.
(1) Make sure that software EPSON RC+ 7.0 is installed to the Controller connected to the
(2) Connect the development PC and the Controller using a USB cable.
(3) Turn ON the Controller.
(4) Start EPSON RC+ 7.0.
(5) Select the EPSON RC+ 7.0 menu-[Setup]-[PC to Controller Communications] to
(6) Select "No.1 USB" and click the <Connect> button.
RC700 Series Rev.3
Do not use the USB hub or extension cable.
PC connection port.
HighSpeed mode.
other USB devices from the development PC. Connection with the Controller may be
lost.
development PC.
(Install the software when it is not installed.)
display the [PC to Controller Communications] dialog.
Functions 7. Development PC Connection USB Port
121