Development Pc Connection Usb Port; About Development Pc Connection Usb Port; Precaution - Epson RC700 Manual

Setup & Operation 5. Development PC Connection USB Port

5. Development PC Connection USB Port

Development PC connection USB port (USB B series connector)
For other details of development PC and Controller connection, refer to EPSON RC+ 7.0
NOTE

User's Guide 5.12.1 PC to Controller Communications Command.
For
then connect the development PC and
If
RC700 / RC700-A
RC+ 7.0 to the development PC, [Add New Hardware Wizard] appears. If this wizard
appears, click the <Cancel> button.

5.1 About Development PC Connection USB Port

The development PC connection port supports the following USB types.
- USB2.0 HighSpeed/FullSpeed (Speed auto selection, or FullSpeed mode)
- USB1.1 FullSpeed
Interface Standard: USB specification Ver.2.0 compliant
Connect the Controller and development PC by a USB cable to develop the robot system
or set the Controller configuration with the EPSON RC+ 7.0 software installed in the
development PC.
Development PC connection port supports hot plug feature. Cables insert and remove
from the development PC and the Controller is available when the power is ON.
However, stop occurs when USB cable is removed from the Controller or the development
PC during connection.

5.2 Precaution

When connecting the development PC and the Controller, make sure of the following:
- Connect the development PC and the Controller with a 5 m or less USB cable.
- Make sure that no other devices except the development PC are used for development
- Use a PC and USB cable that supports USB2.0 HighSpeed mode to operate in USB2.0
- Do not pull or bend the cable strongly.
- Do not allow unnecessary strain on the cable.
40
Development PC connection USB Port
, be sure to install the EPSON RC+ 7.0 to the development PC first,
RC700 / RC700-A
and the development PC are connected without installing the EPSON
(USB Ver.1.1 upward compatible)
Do not use the USB hub or extension cable.
PC connection port.
HighSpeed mode.
with the USB cable.
RC700 / RC700-A
(Figure: RC700)
RC700 / RC700-A Rev.23