Makita DLS110 Instruction Manual page 17

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Blade diameter European countries
Countries other than Europe
Hole diameter European countries
Countries other than Europe
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed (RPM)
Laser type
Rated voltage
Battery cartridge
Charger
Dimensions (L x W x H)
Net weight
Cutting capacities (H x W)
Miter angle
0°
45° (right and left)
60° (right and left)
Cutting capacities for special cuttings
Type of cutting
Crown molding 45° type
(with crown molding stopper used)
Base board
(with horizontal vise used)
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
DLS110
BL1815N, BL1820, BL1820B, BL1830, BL1830B, BL1840, BL1840B,
45° (left)
42 mm x 310 mm
58 mm x 279 mm
42 mm x 218 mm
58 mm x 197 mm
-
Cutting capacity
17 ENGLISH
DLS111
260 mm
255 mm - 260 mm
30 mm
25.4 mm
3.2 mm
Right 60°, Left 60°
Right 48°, Left 48°
4,400 min
- Red Laser 650 nm, Maximum out-
put
D.C. 36 V
BL1850, BL1850B, BL1860B
DC18RC, DC18RD, DC18SD, DC18SE, DC18SF
805 mm x 644 mm x 660 mm
26.6 - 27.3 kg
Bevel angle
0°
68 mm x 310 mm
91 mm x 279 mm
68 mm x 218 mm
91 mm x 197 mm
68 mm x 155 mm
91 mm x 139 mm
168 mm
133 mm
When performing bevel cut, first turn the
1 2 3
knob counterclockwise and then tilt the
carriage. After that, turn the knob clockwise
to tighten.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Hold down the releasing button when tilting
the carriage to the right.
Engage the stopper lever when cutting a
base board in 45° miter angle.
DLS112
-1
1.6mW ( Laser Class 2M )
45° (right)
29 mm x 310 mm
43 mm x 279 mm
29 mm x 218 mm
43 mm x 197 mm
-