Drilling Holes And Setting Anchors - Philips CARDIOMD Service Manual

Procedure
1. Using the template shipped with the
system and a plan of the room layout,
measure the minimum distance to the
walls.
2. Position the template.
3. Use adhesive tape to fix the template to
the floor.
8.3.3.5

Drilling Holes and Setting Anchors

Procedure
1. Drill 6 holes, 2¼" (55 mm) deep, for
anchors through the template. Use the
15 mm masonry drill.
You may use a hammer drill for a pilot hole.
2. Remove the template and clean the holes.
Note. If rebars or tensioning cables in the floor obstruct drilling, use the alternative holes
provided.
Procedure
3. Use a mandrel to set the anchors.
1MAN0158-H11 04-2005 CSIP Level 1
Details
Details
Details
Installation
CardioMD Service Manual 8-31