Casio DT-X11 Series Hardware Manual page 27

Charge output terminal CH1
PIN1: +
PIN2: -
Charge output terminal CH2
PIN1: +
PIN2: -
Input terminal
DC jack
Battery Charge Block
Table 2.12
Item
Charge control
Output voltage
Charge current (standard mode)
Charge current (standby mode)
Full charge detection current
Voltage Full charge detection
control voltage
Re-charge detection voltage
Re-charge detection voltage
Input voltage
Timer
Charge timer (standby mode)
Charge timer (standard mode)
Trickle charge timer
Charge hour
HA-A20BAT
DT-5025LBAT
Temperature control
No. of charge output
Operation mode
Battery pack mount detection
Battery pack not mounted
Battery pack mounted
Check on battery pack
Battery charge (standby mode)
Battery charge (standard mode)
Wait mode in trickle charge
Charge in trickle mode
Charge completed
Charge abnormal end
Other
Priority order of battery charging
4.22V±30mV
GND
4.22V±30mV
GND
Rated DC16V, input voltage DC 8.0 to 20.0V
DC 4.22V±30mV
DC 1,600mA±10%
DC 160±40mA
DC 120±30mA
4.1V
4.0V
DC 4.0±0.1V
DC 8.0 to 20V
90 minutes
720 minutes
120 minutes
Approx. 2.5 hours (for 1 pack)
Approx. 5 hours (for 2 packs at same time)
Approx. 5 hours (for 1 pack)
Approx. 10 hours (for 2 packs at same time)
Not available
1
LED OFF, charge output OFF
LED ON in red, charge output OFF
LED ON in red, charge output OFF
LED ON in red, charge output ON
LED ON in red, charge output ON
LED ON in green, charge output OFF
LED ON in green, charge output ON
LED ON in green, charge output OFF
LED flash in red, charge output OFF
Order in mounted order
27
Specification Remark
At 0 to 40 ºC
At 0 to 40 ºC