Casio DT-X11 Series Hardware Manual page 11

10 Function Keys
11 IR Port
12 Power Contacts
13 CLR Key
14 Fn Key
15 PC Card Slot
16 USB Port
17 Headset Jack
18 Battery Pack Cover Lock
Switches
19 R Trigger Key
20 L Trigger Key
21 Wrist Strap Hole
22 C-MOS Imager (C-MOS
Imager models only)
Reader Port (Laser Scanner
models only)
23 Reset Switch
24 CF Card Slot Unit Terminal
25 Battery Pack Cover
These keys can be assigned any function other than barcode reading.
The following are the initial default settings.
F1 : Deletes one character to the left.
F2 : Inputs a hyphen (-).
F3 : Inputs a period (.).
F4 : Toggles to switch between numbers and alphabets.
This port is used for IR communication with another Handheld
Terminal or Bridge Satellite Cradle.
Contact point for supplying power from Bridge Satellite Cradle and
Cradle-type Battery Charger.
Press to clear all key inputs.
Press this key and then a function key or number key to configure
settings or to run previously registered applications.
For insertion of a separately available PC card.
For connection to a computer or other device using a USB cable.
For connection of a commercially available headset (2.5mm).
Slide these switches to lock and release the battery pack cover.
Press to perform a code read operation. This is also pressed to perform a
full reset.
Press to perform a code read operation. This is also pressed to cancel a
full reset.
Connect the wrist strap here.
Reads 1D bar codes and 2D codes.
Reads 1D bar codes.
Press to reset the Handheld Terminal.
For connection of a separately available CF Card Extension Unit.
Covers the compartment that holds the battery pack.
11